Havis Shields Automobile Accessories C 3610 CV User Manual

INSTALL INSTRUCTIONS C-3610-CV

PENTAX PRINTER MOUNT ‘96-08 FORD CROWN VICTORIA

TOOLS REQUIRED:

Power Drill

Drill Bit Set

Phillips Screwdriver

Wire Crimping Tool

HARDWARE:

QTY DESCRIPTION

PART #

#10 X ½” Sheet metal screw

GSM33194

GSM33195

CM86508

GSM33118

#10 X ¾” Sheet metal screw

#8 X 3/8” Black torx screw

#10 X ½” Machine screw

REMOVE:

1. Using Phillips screw driver, remove existing inner plastic glove box assembly.

(Do not remove glove box door)

INSTALLATION:

1. Subassembly:

• Position printer housing inside glove box

opening on left side. (Approximately 1”

inch from side)

• Using the housing hinge as a template,

mark the three mounting holes.

• The hinge rod should be above the glove

box fame. This is critical to allow the

glove box door to close.

• Drill (3) 9/64” holes

Housing Hinge Location

2. Glove box filler:

• The 2000 and newer model years

requires a glove box door filler (CM93605).

• Attach this filler with (5) #8 X 3/8” Black torx screws.

• On vehicle model years 1996-1999 – remove glove box retractor.

Note: 1999 and older models do not get this filler.

3. Mount Printer Housing:

Note: Printer should Not be in the housing yet.

• Mount housing assembly using (3) #10 x ¾” sheet metal screws.

(These screws go through the hinge and the holes you drilled in subassembly)